Regina Scissor Lift Certification

Regina Scissor Lift Certification - Scissor lift platforms are made use of at work locations to be able to allow tradespeople - like for example masons, iron workers and welders - to reach their work. Using a scissor lift platform is normally secondary to their trade. Hence, it is important that all operators of these platforms be trained correctly and certified. Regulators, industry and lift manufacturers work together to ensure that operators are trained in the safe utilization of work platforms.

Scissor lift work platforms are otherwise called manlifts or AWPs. These work machines are rather easy to use and offer a stable work surroundings, however they do have risks as they raise people to heights. The following are some important safety concerns common to AWPs:

There is a minimum safe approach distance (MSAD) for all platforms so as to protect from accidental power discharge due to nearness to power lines and wires. Voltage could arc across the air and cause injury to staff on a work platform if MSAD is not observed.

To ensure maximum steadiness, caution must be taken when lowering the work platform. Moving the load towards the turntable, the boom must be retracted. This would help maintain steadiness if the -platform is lowered.

Rules do not mandate people working on a scissor lift to tie off. Nevertheless, workers might be required to tie off if needed by employer guidelines, job-specific risk assessments or local regulations. The manufacturer-provided anchorage is the only safe anchorage wherein lanyard and harness combinations must be attached.

Observe the maximum slope rating and do not go beyond it. A grade can be measured by laying a board or straight edge on the slope. Next, a carpenter's level could be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the straight edge's length, then multiplying by 100, the per cent slope could be determined.

A regular walk-around check needs to be performed to determine if the unit is mechanically safe. A site assessment determines if the work area is safe. This is important specially on changing construction locations due to the chance of obstacles, contact with power lines and unimproved surfaces. A function test must be carried out. If the unit is used properly and safely and correct shutdown procedures are followed, the risks of accidents are greatly lessened.

Click to Download the pdf